Kittiwake Rasta Hat 3

Gauge 2.5 st to 1 in (brim)
Gauge 3.25 st to 1 in (Chart A cable)
Yarn: Malabrigo Rasta in Soriano and Stitch Red
DPN Size 9

Circumference 22 inches


Brim: k1p1 for 4 in (10cm)
Hat body (pattern part) is 17 cm, which is 7 in
Circumference of Kittiwake pattern is 56 cm, which is 22 in.

Brim: k1p1 for 3 in
Hat body 7 in
Circumference 22 in

Book: Aran Knitting, Alice Starmore, Kittiwake Hat, page 133 (charts)

CO 54 st
I used a two color long tail cast on.
I’m not using the red yarn past the cast on.

Chart A = Hat, 23 st wide, 37 st high

Gauge at this pattern is 3.25 st to 1 in

Can make shorter, remember to do a 5 to 1 decrease in center of pattern at top row. This would look best at row 37, 25, 13 and 3.










Chart B = Brim decreases, 19 st wide, 24 st high
Decreases are at row 8, 13, 19, and 24. So every 5 rows, two st per repeat disappears. Two repeats, so that is four st. [RECALCULATE] Gauge of 2.5 st to 1 in, that means 1.6 in disappears every five rounds. That actually sounds fine, take a look again when you get there.



After Chart B:

Round 1: p

Round 2: p2tog, p3, p2tog

Round 3: p2tog, p1, p2tog

Break off yarn and put through remaining st on needle. Tighten. Fasten off if you don’t want a pom pom or a tassel.

If you want a pom pom or tassel, refer to the book p. 132.


2 thoughts on “Kittiwake Rasta Hat 3

So... whaddya think?

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s